Guangzhou Crystal Light Electronic Products Co., Ltd.
Crystal Light Electronic Products Co., Ltd.
Add to Cart
Product Parameter
| Part Numbers | 5J.JLV05.001 5J.JLT05.001 |
| Fittable projector models | For BENQ Projector Lamp EH600 EW600 EX600 EX800ST |
| Bulb Type | 200 W |
| Life time | 3000 -5000(Hours) |
| Packing | Carton box with foam |
| Minimum Order quantity | 10 piece |
Product Information
The BENQ 5J.JLV05.001 5J.JLT05.001 replacement lamps are compatiable with EH600 EW600 EX600 projectors.The working hour time is:3000-5000 hours,After repalcing our new lamps,the projector performance can be the same of the new original one and improve the effect of projection,and make you feel comfortable while using.
Connect the power
To ensure that the power supply meets the projector's requirements, plug the projector's power cord into an electrical outlet.
Bulb warranty
Refer to the User Manual: Consult the user manual provided by the projector manufacturer for specific instructions on lamp replacement. The manual will provide detailed information on the lamp type, installation procedure, and any additional precautions specific to your projector model.
Allow Lamp to Cool: Projector lamps generate heat during operation. It is crucial to allow the lamp to cool down completely before attempting to replace it. This prevents the risk of burns or damage to the new lamp.
Use Proper Tools: Prepare the necessary tools for the installation, such as a screwdriver or lamp removal tool, as specified in the user manual. Using the correct tools will ensure a secure and safe installation.
Access the Lamp Compartment: Locate the lamp compartment on your projector. The exact location may vary depending on the projector model. Usually, it is accessible from the top or bottom of the projector or through a side panel. Remove any screws or latches that secure the compartment.
Remove the Old Lamp: Carefully detach the old lamp by following the instructions provided in the user manual. In some cases, the lamp may be held in place by screws or clips. Gently release the lamp and disconnect any cables or connectors attached to it.
