Guangzhou Crystal Light Electronic Products Co., Ltd.
Crystal Light Electronic Products Co., Ltd.
Add to Cart
Product Parameter
| Part Numbers | BL-FU240H SP.7G901GC01 |
| Fittable projector models | For OPTOMA Projector Lamp HD28HDR HD28H HD29HE VDHDNTEH HD15 HD146X |
| Bulb Type | 240 W |
| Life time | 3000 -5000(Hours) |
| Packing | Carton box with foam |
| Minimum Order quantity | 10 piece |
Product Information
The OPTOMA BL-FU240H SP.7G901GC01 replacement lamps are compatiable with HD28HDR HD28H HD29HE projectors.The working hour time is:3000-5000 hours,After repalcing our new lamps,the projector performance can be the same of the new original one and improve the effect of projection,and make you feel comfortable while using.
Connect the video source
Common options include VGA, HDMI, or DisplayPort cables. Connect one end of the cable to the video output port of the source device (such as a laptop or DVD player), and use the appropriate cable to connect the video source to the projector based on your setup.
Bulb warranty
Allow Lamp to Cool: Projector lamps generate heat during operation. It is crucial to allow the lamp to cool down completely before attempting to replace it. This prevents the risk of burns or damage to the new lamp.
Use Proper Tools: Prepare the necessary tools for the installation, such as a screwdriver or lamp removal tool, as specified in the user manual. Using the correct tools will ensure a secure and safe installation.
Access the Lamp Compartment: Locate the lamp compartment on your projector. The exact location may vary depending on the projector model. Usually, it is accessible from the top or bottom of the projector or through a side panel. Remove any screws or latches that secure the compartment.
Remove the Old Lamp: Carefully detach the old lamp by following the instructions provided in the user manual. In some cases, the lamp may be held in place by screws or clips. Gently release the lamp and disconnect any cables or connectors attached to it.
Install the New Lamp: Take the new lamp and align it correctly with the lamp housing. Make sure it fits securely and matches the connections of the previous lamp. Reconnect any cables or connectors that were disconnected during the removal process.
