Guangzhou Crystal Light Electronic Products Co., Ltd.
Crystal Light Electronic Products Co., Ltd.
Add to Cart
Product Parameter
| Part Numbers | 114-303 |
| Fittable projector models | For Digital Projection HIGHlite Projector Lamp Digital Projection HIGHlite 730 1080p 3D Digital Projection HIGHlite 740 1080P 2D Digital Projection HIGHlite 740 WUXGA 2D |
| Bulb Type | 370 W |
| Life time | 3000 -4800(Hours) |
| Packing | Carton box with foam |
| Minimum Order quantity | 10 piece |
Product Information
The Digital 114-303 replacement lamps are compatiable with HIGHlite 730 1080p 3D HIGHlite 740 1080P 2D HIGHlite 740 WUXGA 2D projectors.The working hour time is:3000-4800 hours,After repalcing our new lamps,the projector performance can be the same of the new original one and improve the effect of projection,and make you feel comfortable while using.
Managing Lamp Usage
Projector lamps have a limited lifespan. Monitor the lamp usage and replace it when necessary. Use the projector's built-in lamp hour counter or consult the user manual for instructions on how to access the lamp usage information.
Bulb warranty
Access the Lamp Compartment: Locate the lamp compartment on your projector. The exact location may vary depending on the projector model. Usually, it is accessible from the top or bottom of the projector or through a side panel. Remove any screws or latches that secure the compartment.
Remove the Old Lamp: Carefully detach the old lamp by following the instructions provided in the user manual. In some cases, the lamp may be held in place by screws or clips. Gently release the lamp and disconnect any cables or connectors attached to it.
Install the New Lamp: Take the new lamp and align it correctly with the lamp housing. Make sure it fits securely and matches the connections of the previous lamp. Reconnect any cables or connectors that were disconnected during the removal process.
Secure the Lamp Compartment: Once the new lamp is in place, secure the lamp compartment by reattaching any screws or latches that were removed earlier. Ensure that the compartment is sealed properly to prevent any dust or debris from entering.
Reset Lamp Timer: After installing the new lamp, it is essential to reset the lamp timer on the projector. This step varies by projector model, so refer to the user manual for instructions on how to reset the lamp timer.
